|
| |
TM5-4930-235-13&P
Table 4-1. Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
1. OUTLET CAP ASSEMBLY DAMAGED - (CONT).
Step 3. Inspect o-ring for cuts, tears, or cracks.
If damaged, remove from outlet cap and install new o-ring.
2. DUST PLUG DAMAGED.
Step 1. Inspect dust plug for corrosion, cracks, or distortion.
If damaged, remove from wire rope. Install new dust plug.
Step 2. Inspect wire rope for corrosion, cuts, fraying, and crimp of sleeves to wire rope.
If damaged, remove from dust plug and nozzle. Install new wire rope and sleeves.
3. GROUND PLUG ASSEMBLY DAMAGED.
Step 1. Inspect ground plug for corrosion, cracks, or distortion.
If damaged, remove from wire. Install new ground plug.
Step 2. Inspect wire and ring terminal for corrosion, cuts, fraying and crimp of ring terminal to wire.
If damaged, remove from ground plug and nozzle. Install new wire and ring terminal. Perform continuity
check.
4. GROUND CLIP ASSEMBLY DAMAGED.
Step 1. Inspect ground clip for corrosion, cracks, or distortion.
If damaged, remove from wire rope. Install new ground clip. Perform continuity check.
Step 2. Inspect wire rope and ring terminal for corrosion, cuts, fraying, and crimp of ring terminal to wire rope.
If damaged, remove from ground clip and nozzle. Install new wire rope and ring terminal. Perform continuity
check.
5. NOZZLE INLET ASSEMBLY DAMAGED.
Step 1. Inspect inlet nozzle assembly for corrosion, cracks, or distortion.
If damaged, disassemble and replace damaged parts.
4-2
|
