|
| |
TM 5-4320-313-14
5-9. CYLINDER HEAD AND VALVE ASSEMBLY - Continued.
e. Adjustment - Continued.
(10)Install gasket (6, figure 5-17) and cover (5) on cylinder head and secure with two lockwashers (4) and two
nuts (3).
(11)Install clip (2) and secure with screw (1).
(12)Install cowling (3) (figure 5-16) and secure with nut (2) and screw (1).
(13)Refer to paragraph 5-6 and install injector.
(14)Refer to paragraph 4-16 and install muffler.
(15)Refer to paragraph 4-15 and install fuel tank.
5-10.
CYLINDER.
This task consists of:
a. Removal b. Cleaning
c. Inspection
d.Installation
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Piston Ring Clamp (item 22, appendix B)
Caliber Set (item 3, appendix B)
Materials Required:
Oil, Lubricating (item 6, appendix E)
Rags, Wiping (item 8, appendix E)
Solvent, Cleaning (item 10, appendix E)
General Safety Instructions:
Well-ventilated area required.
Equipment Conditions:
Cylinder head removed in accordance with paragraph 5-9.
a. Removal.(Refer to figure 5-24).
CAUTION
When removing cylinder, make sure piston or connecting rod does not knock against crankcase. This
could result in serious damage to piston or connecting rod.
5-36
|
