|
| |
TM 5-4320-313-14
6-4. GOVERNOR.
This task consists of:
a. Removal b. Cleaning c. Inspection d.Repair
e. Installation
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Shop Set, Automotive Repair, Field Maintenance, Basic (item 3, appendix B)
Extractor for Gear, Crankshaft 618 168 00 (item 12, appendix B)
Impact Mandrel, Gear on Crankshaft 666 069 00 (item 14, appendix B)
Special Tool for Governor Spring 618 305 00 (item 15, appendix B)
Materials Required:
Oil, Lubricating (item 6, appendix E)
Packing, P/N 40021700
Rags, Wiping (item 8, appendix E)
Solvent, Cleaning (item 10, appendix E)
General Safety Instructions:
Well-ventilated area required.
Equipment Conditions:
Timing cover and camshaft removed in accordance with paragraph 6-3.
Cranking gears removed in accordance with paragraph 5-8.
a. Removal.(Refer to figure 6-9).
(1) Remove two nuts (1), lever (2), nut (3), and disc (4).
(2) Remove gear (5) using extractor. Remove disc (6) and shell (7) from crankshaft.
(3) Remove threaded pin (10) and nut (11) from lever (20).
(4) Remove four pins (8 and 9) from shaft (17).
(5) Remove cap (12), nut (13), plate (14), packing (15), and eccentric pin (16). Discard packing (15).
(6) Lightly push shaft (17) from crankcase.
(7) Remove washer (18) and two packings (19). Discard packing (19).
(8) Remove lever (20) and spring (21) from crankcase.
6-14
|
