|
| |
TM 5-4320-313-14
6-3. TIMING COVER AND CAMSHAFT.
This task consists of:
a. Removal b. Disassembly c. Cleaning d.Inspection
e. Repair f. Reassembly
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Shop Set, Automotive Repair, Field Maintenance, Basic (item 3, appendix B)
Auxiliary Bush, Timing Cover Oil Seal (30 x 47 mm) 666 075 00 (item 7, appendix B)
Extractor, Cam Follower Spindle 666 324 00 (item 8, appendix B)
Mounting Device, Camshaft Needle Bearing 666 418 00 (item 9, appendix B)
Materials Required:
Gasket, P/N 03209202
Oil Seal, P/N 40033700
Rags, Wiping (item 8, appendix E)
Solvent, Cleaning (item 10, appendix E)
General Safety Instructions:
Well-ventilated area required.
Equipment Conditions:
Cylinder head removed in accordance with paragraph 5-9.
Cranking gears removed in accordance with paragraph 5-8.
a. Removal.(Refer to figure 6-7).
CAUTION
Lift both cam followers from camshaft when removing timing cover to prevent bending by cam points.
(1) Remove four screws (1), two screws (2), five washers (3), timing cover (4), and camshaft (14) as a unit.
NOTE
Insertion of allen screws (8 mm dia., 1-1/2 inches long) in timing cover holes will aid in removal of timing
cover.
(2) Remove and discard gasket (5).
(3) Remove plastic plug (6) above fuel injection pump, and remove setscrew (7) from crankcase.
(4) Remove spindle (8), cam followers (9 and 10), and shim (11) from crankcase using extractor.
6-10
|
