|
| |
TM 5-4320-313-14
5-12.
FLYWHEEL.
This task consists of:
a. Removal b. Cleaning c. Inspection d.Installation
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Torque Wrench (item 2, appendix B)
Socket (item 25, appendix B)
Materials Required:
Rags, Wiping (item 8, appendix E)
Solvent, Cleaning (item 10, appendix E)
General Safety Instructions:
Well-ventilated area required.
Equipment Conditions:
Pump assembly removed in accordance with paragraph 5-4.
a. Removal.(Refer to figure 5-31).
(1) Remove four screws (1), four lockwashers (2), and housing (3).
(2) Remove three screws (4), three lockwashers (5), and stub shaft (6).
(3) Remove four screws (7), four lockwashers (8), and flywheel (9).
(4) Remove six screws (10), six lockwashers (11), and blower ring (12).
b. Cleaning.
WARNING
Do not breathe cleaning solvent P-D-680 vapors for long periods of time or use solvent near open
flames. To avoid illness, explosion, or fire, only use solvent in well-ventilated areas away from open
flames.
(1) Clean all parts with a rag and cleaning solvent.
(2) Allow to dry.
c. Inspection.
(1) Inspect blower ring for cracked, chipped, or missing blades.
5-44
|
