|
| |
TM 5-4320-313-14
Figure 5-29. Piston Rings Installation.
f. Installation. (Refer to figure 5-30).
(1) Install one circlip (1) in lip groove of piston (3) gudgeon bore.
CAUTION
When installing piston, make sure piston or connecting rod does not knock against crankcase. This
could result in serious damage to piston or connecting rod.
(2) Insert connecting rod (4) into bottom of piston (3). Make sure that opening of combustion chamber is on the
flywheel side.
(3) Insert gudgeon pin (2) into piston (3) gudgeon bore and through rod bushing of connecting rod (4). Push in
gudgeon pin until it contacts installed circlip (1) and stops.
(4) Install other circlip (1).
Figure 5-30. Piston Installation.
(5) Refer to paragraph 5-10 and install cylinder.
5-43
|
