|
| |
TM 5-4320-306-24
3-18. REPAIR ALTERNATOR, V-BELT PULLEY, AND FAN (Continued)
2
Remove four through bolts (1) and four nuts (2).
3
Remove alternator (3) from vise.
WARNING
If the brush assembly has not been removed, it will spring out when rear housing is separated
from the front housing. Flying parts may cause serious injury.
CAUTION
Do not insert screwdriver more than 1/16 inch (1.6 mm) deep between the two housings to avoid
damage to stator.
4
Insert two small-bladed screwdrivers between front housing (4) and rear housing (5) and carefully pry apart.
Separate the two housings. Rear bearing retainer may remain in rear housing.
5
Remove front bearing retainer (1) from recess in
front housing (2) by using a long-nose pliers to
compress the ears of front bearing retainer; lift
bearing retainer out of housing.
6
Use a wooden block to tap on the shaft of rotor
(3) to free it from front housing (2).
CAUTION
Do not press on inner race of bearing
during removal. Excessive pressure on
the inner race may damage the bearing.
7
Remove front bearing (4) and rear bearing (5)
from rotor (3) by using a bearing puller.
3-88
|
