|
| |
TM 5-4320-305-24
2-19. REPLACE/REPAIR DISCHARGE MANIFOLD ASSEMBLY AND
DISCHARGE ELBOW
This task covers: a. Removal
c. Cleaning/lnspection/
d. Assembly
b. Disassembly
Repair
e. Installation
INITIAL SETUP
Tools
Equipment
Condition
Shop equipment, automotive maintenance and
Para
Condition Description
repair, common no. 1
2-16
Control panel cover assembly, con-
Tool kit, general mechanics automotive
trol panel assembly, and control
panel base plate removed.
Materials/Parts
2-28
Muffler guard removed.
Crocus abrasive cloth (Item 1, Appendix C)
REMOVAL:
WARNING
Death or serious injury could occur if unauthorized or unnec-
essary personnel are in the hoisting area. Permit only personnel
actually engaged in the hoisting operation to be near the unit and
hoisting equipment. All instructions for the hoisting operations
must come from one authorized person.
Injury to personnel or damage to equipment could occur from
improper hoisting. Hoist the load slowly to avoid tearing out lifting
bail assembly, slipping slings, or load shift. Do not jerk the load or
swing it from side-to-side when hoisting. This places additional
stress on hoisting components which can cause failure and loss of
load. Be sure hoisting equipment is on solid footing and is
suitable for the size of the load. Watch boom angle and overhead
clearance when hoisting.
1 Position a suitable lifting device (1) equipped with a spreader bar and slings over discharge manifold assembly (2).
2 Attach slings around assembly and put tension on slings. Make sure assembly is properly supported. Spread slings
on spreader bar so that slings hang vertically when attached to assembly.
3 Remove remaining six nuts and six lockwashers (3).
NOTE
Two nuts and two lockwashers were removed when the muffler guard was removed for access.
2-76
|
