|
| |
TM 5-4320-305-24
4-4. REPAIR INJECTION PUMP (Continued)
43 Install screw (146) into lever (145).
44 Place lever (145) in position inside governor cover (20).
45 Install washer (143) and bearing bushing (142) into governor cover (20).
46 Install washer (139) and bearing bushing (138) while guiding lever (145) into bearing bushings (138 and 142).
47 Install two C-clips (137 and 141).
48 Install capsule (140).
49 Install screw plug (144).
50 Install two washers (135 and 136).
51 Install control lever (134) onto lever (145).
52 Install washer (133), lockwasher (132), and bolt (131).
53 Install two washers (130) and bracket (129).
54 Install two washers (128) and two bolts (127).
55 Install threaded pin (126) and nut (125).
56 Place sliding pad (124) onto clevis (116).
57 Slide shaft (117) onto clevis (116).
58 Install the following parts into bore of clevis (116): spring capsule (123) and compression springs (122, 121, and 120).
Install spring-loaded retainer (119) onto clevis (116).
59 Install threaded bushing (118) into governor cover (20).
60 Install shaft (117) and clevis (116) assembly into threaded bushing (118).
61 Use wrench and screwdriver to install banjo bolt (114) and nut (115) into governor cover (20).
62 Install studpin (113) and parallel pin (112).
63 Install threaded bushing (109).
64 Install washer (111) and shim (110), and place shutdown lever (108) into position.
65 Install lockwasher (105) and screw (104).
66 Install washer (107) and screw plug (106).
67 Mount injection pump body in vise.
4-31
|
