|
| |
TM 5-4320-305-24
2-6. SETUP INSTRUCTIONS
The centrifugal pump unit can be used individually or in a hoseline operation. Refer to Operator's Manual, TM 5-4320-
305-10, for setup and operating instructions.
2-7. INSPECTING AND SERVICING EQUIPMENT
a. Inspect centrifugal pump unit for any damage that may have occurred during shipping.
b. Inspect unit for loose mounting hardware.
c. Refer to paragraph 2-1 for lubrication instructions.
d. Refer to table 2-1 and perform preventive maintenance checks and services.
2-8. INSPECTING AND SERVICING BATTERIES
a. The centrifugal pump unit battery box (1) contains two waterproof, lead acid storage batteries (2).
CAUTION
Disconnect battery cable from negative battery post before disconnecting any
other leads from engine components. This precaution will prevent short circuits
which could damage the alternator, voltage regulator, or other electrical
components.
When removing battery cable, use battery terminal puller to remove loosened
terminal lugs. Forcing battery terminal lugs off without using puller may damage
the battery posts.
Never disconnect battery while alternator is operating.
Never attempt to polarize the alternator.
b. Open battery box top (3). Remove battery cables and batteries (2) from battery box (1) and inspect for
damage.
c. Clean positive terminals (4) and negative terminals (5).
2-8
|
