|
| |
TM 5-4320-305-24
2-24. REPLACE/REPAIR THROTTLE ACTUATOR, QUICK RELEASE LINK, AND MAGNETIC
PICKUP (Continued)
7 Tag and disconnect wire leads (1) from magnetic
pickup (2).
8 Loosen locking nut (3).
9 Unscrew magnetic pickup (2) from adapter housing
(4).
CLEANING/INSPECTION:
WARNING
Dry cleaning solvent P-D-680 (safety or Stoddard's Solvent) is
potentially dangerous. Avoid repeated and prolonged breathing of
vapors and skin contact with the liquid. Do not use near open
flame, arcing equipment, or other ignition sources. Always wear
eye protection and protective clothing. The flash point of P-D-680
is 100° to 138° F (38° to 59°C).
Death or serious injury could occur if compressed air is directed
against the skin. Do not use compressed air for cleaning or drying
unless the pressure is/has been reduced to 30 psi (2.11 kgcm2) or
less. When working with compressed air always use chip guards,
eye protection, and other personal protective equipment.
1 Clean lever extension and actuator arm parts with dry cleaning solvent to remove all traces of grease and oil. Dry all
parts with compressed air. Inspect for rust, corrosion, or other damage. Replace if severely rusted or damaged.
2 Inspect for damage or distortion that would prevent free action of the actuator or injector throttle lever.
2-96
|
