Cleaning and Inspection. - TM-5-4320-273-140135

TM 5-4320-273-14

(6) Remove the ground rods (12) by removing the

necessary. Straighten distorted or bent structural

members or towing tongue,

anchor pin assembly (13) from the rear rod tube. The

ground wire assembly (19) is stowed in the tool box

(3) Inspect for bent or damaged ground rods (12)

which was removed previously.

and ground wire assemblies (19). If you cannot

(7) Remove the nuts (22), lockwashers (23), and

straighten or repair ground rods or repair the ground

wire assemblies, replace them.

screw (24) that secure the bonding strap to the frame

(25).

(4) Check the wear of the spacer (9) which

enables raising or lowering of the front stand;

b. Cleaning and Inspection.

replace if excessively worn.

WARNING

(5) Replace other damaged or missing parts.

DRY CLEANING SOLVENT, P-D-680

or P-S 661, used to clean parts is

c. Reassembly and Installation,

(1) Install bonding strap to frame (25) rising nuts

potentially dangerous to personnel

(22), lockwashers (23), and screw (24).

and property. Avoid repeated and

(2) Install ground rods in rod tube and secure

prolonged skin contact. DO NOT use

with anchor pin assembly (13).

near open flame or excessive heat.

(3) Replace front stand. Secure with anchor pin

Flash point of solvent is 100 to 138F

assembly (l), nuts (7), lockwashers (8), spacers (9), and

(38 to 60C).

screws (10).

(1) Clean all parts with cleaning solvent (fed.

(4) Install tongue, secure with tongue pin.

spec. P-D-680); dry thoroughly.

(2) Inspect all parts for rust, corrosion, cracks,

(5) Install tool box. Stow ground wire assembly

(19) in tool box.

and distortion. You can remove rust or other

(6) Install wheel and axle assemblies.

corrosion by using sandpaper, a metal scraper, or a

(7) Install pump and engine assemblies.

wire brush. Prime and paint bare surfaces as

8-5