Figure 44. Magneto-to-spark plug connections.

TM 5-4320-273-14

Table 4-2. Troubleshooting -- Continued

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

ENGINE -- Continued

Replace spark plug cables as follows:

Disconnect connections to spark plugs (4) and magneto (5). Remove screw (6), washer (7), and cable clip (8)

from each cable to be replaced. Install serviceable shielded spark plug cables to magneto and spark plugs.

Make sure leads are not interchanged. Refer to figure 4-4 to assure proper magneto-to-spark plug wiring.

Secure cables by installing cable clip (8, fig. 4-3), washer (7), and screw (6).

Figure 44. Magneto-to-spark plug connections.

Check magneto points for proper gap clearance and defective capacitor.

Step 2.

Remove screws and assembled washers (1 and 2, fig. 4-5) that secure the end cap assembly (2) to the housing

(4). Remove the end cap from the housing without disconnecting the spark plug cables.