CHAPTER 2. OPERATING INSTRUCTIONS - TM-5-4320-272-120025

OPERATING

INSTRUCTIONS

Section I. OPERATING PROCEDURES

2-1. General

assembly, you must become familiar with all

controls and instruments provided on the unit.

This section contains information and guidance for

Refer to table 2-1 for a complete description and

the personnel responsible for operation of the

identification of all controls and instruments used

pumping assembly. This section gives instructions

on the pumping assembly. The controls and in-

on starting and stopping the pump and basic

struments are illustrated in figures 2-1 through 2-3.

operations of the unit.

2-2. Controls and Instruments

Before attempting to operate the pumping

1. Throttle control

Engine tachometer-hourmeter

2. Ammeter

Pump discharge pressure gage

3. Oil pressure gage

Engine vacuum gage

4. Oil pressure safety switch plunger

10.

Pump suction gage

5. Magneto switch

11.

Engine choke control

6. Starter - switch

Figure 2-1. Control panel controls and instruments.