|
|
Figure 2-6-Continued.
Section IV. OPERATION OF EQUIPMENT
2-10. General
(1) Never operate the pump unless liquid is
Rowing through it. An empty pump will rapidly overheat
a. Instructions in this section are published for
and cause serious damage.
information and guidance of personnel responsible for
operation of the pumping assembly.
(2) Do not crank the engine for a period of
more than 30 seconds continuously. A pe iod longer
r
b. The operator must know how to perform every
than 30 seconds can damage the starter. If the engine
operation of which the pumping assembly is capable.
does not start after a few tries, stop cranking and
This section gives instructions on starting and stopping
determine the cause.
the pumping assembly, basic motions of the pumping
assembly, and on coordinating basic motions to perform
(3) Perform necessary daily preventive
specific tasks for which the equipment is designed.
maintenance services. (pare 3-6).
Since nearly every job presents a different problem, the
operator may have to vary given procedures to fit the
(4) Check load requirements.
individual job.
Caution
2-11. Starting
The small doors on the larger side
doors (fig. 1-3) must remain open
a. Before attempting to start the engine, the
during engine operation or engine
operator shall note the following precautions:
will overheat.
assembly.
2-10
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |