 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 Figure 354. Magneto removal and inati4llaon
(1) Refer to figure 60 and remove capscrews
This is done in the following manner: momentarily
(11), lockwashers (12), and side (10).
connect a 24-volt battery in a series between the field
lead (B terminal fig. 6-6) and a common ground.
(Grounded side of the battery must be the same as the
(2) Refer to figure 8-21 and remove the
battery in the unit. ) This allows a surge of current to
generator regulator.
flow through the field circuit to ground and properly
polarizes the generator for the unit battery.
e. Installation.
Install generator regulator in
reverse
order of removal.
3-44. Generator Regulator
3-45. Starting Motor
the lower left hand side of the engine block. It includes
a cutout relay, voltage regulator, and current regulator.
a. General. The starting motor is of 24 volt type
and is located on the right hand side of the engine
connections and well insulated wiring.
mounted to the flywheel housing. When in operation, it
Inspect mounting bolts and cover.
engages the ring gear on the flywheel to rotate the
c. Test. Start pumping unit and permit engine to
engine crankshaft.
warm up. Check ammeter (2, fig. 2-4)
3-22 if it shows discharge check electrical system
b. Test. Operate magneto switch to off, push in
further.
starter button so that the engine turns over a few 'times.
d. Removal.
The engine should turn over quietly and quickly.
3-22
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals