Table 2-1. Troubleshooting-continued

TM 5-4320-234-34

Table 2-1. Troubleshooting - Continued

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

ENGINE CONTINUED

(2) Using a new head gasket, install cylinder head as shown in figure 2-1.

Tighten the cylinder head screws according to the sequence shown in figure 2-2. Torque to 35 to 40 foot-pounds (4.84 to

5.53 kgm).

Figure 2-2. Cylinder head capscrew tightening sequence

Step 2.

Check for bad piston rings or burned or warped valves.

a. Follow step-by step procedures listed on figure 2-3 and perform compression test.

2-3