|
| |
TM 5-4320-228-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Section I.
LUBRICATION INSTRUCTIONS
3-1.
GENERAL LUBRICATION INFORMATION.
The engine is the only component of the centrifugal pump that
requires lubrication.
The pump uses prelubricated, sealed ball
bearings that require no further lubrication.
3-2.
DETAILED LUBRICATION INFORMATION.
Refer to the current lubrication order LO 5-2805-203-14 and to
TM 5-2805-203-14 for engine lubrication instructions.
When OES oil is used, it will be checked more
often.
Section II.
TROUBLESHOOTING
3-3.
GENERAL.
The table lists the common malfunctions which you may find during
the operation or maintenance of the pump or it’s components.
You
should perform the tests/inspections and corrective actions in the
order listed.
This manual cannot list all malfunctions that may occur, nor all
test or inspections and corrective actions.
If a malfunction is not
listed or is not corrected by listed corrective actions, notify your
supervisor.
Refer to TM 5-2805-203-14 for engine troubleshooting.
3-1
|
