|
| |
APPENDIX A
BLADE SLOT CLEARANCE
Blades should move freely in Rotor slots and the average
clearance in each slot should not exceed the listed
clearances.
BLADE END CLEARANCE
Place a Depth Micrometer on the Rotor over the Blade End as shown. If a Depth Micrometer is not
available, a Feeler Gauge may be used. Lower edge of Blade should not project below bottom surface
of Rotor.
SPECIAL TOOLS REQUIRED
1. FEELER GAUGES
2. FLATMETAL SURFACE WITH
OPENING TO RECEIVE SHAFT
SPECIAL TOOL REQUIRED
1. DEPTH MICROMETER OR FEELER
GAUGE
A9-41
|
