|
| |
2-4.8
Sampling Assembly(1 Unit)
NSN
a.
A Sampling Assembly is located on the inlet line to the switching manifold for each TPT to permit periodic
sampling and quality control. See Fig. 2-1. The exact location will be shown in technical manuals for the specific site.
b.
The unit consists of a pipe section with double grooved ends, a 1/2" tap into the line, a 1/2" ball valve, a 1/2"
needle valve, a gooseneck spigot, and a catch basin. See Fig. 22 for detail.
2-4.9
Range Poles (36 Units)
NSN 6685-00-514-5575
a.
A range pole is made of two sections of steel tubing of nominal 1 1/8-inch outside diameter and of nominal
0.032-inch wall thickness. The assembled length is 6-1/2 feet, including a hardened steel point permanently fastened to
the lower end. The steel point is concentric to the centerline of the pole. A spring catch locks the two sections rigidly
together. The two sections of the pole are fitted in a two-pocket carrying case made of cotton duck.
b.
The range poles are used to roughly gage and estimate the fuel in the collapsible tanks in the TPT. Two poles
are supplied for each 5,000 Bbl tank. They are mounted on opposite sides of the tank in the berm and a cord is stretched
across the tank. The level of the cord can be set as best suits the operator; however, it is recommended that the level be
set at the full height of the tank, i.e., 6'-8" from the pad. It is also recommended that a readily visible ball or other object
be mounted on the cord at the center of the tank. See Figure No. 2-23.
2-4.10
Roadway Crossing Guards (20 Units)
NSN 3835-01-187-1556
a.
Roadway Crossing Guards are simple metal channels, so constructed as to fit over the hose with no sharp or
rough edges to damage the hose walls. See Figure No. 2-24.
b.
The guards are located and used principally in road crossings, as shown in Figure No. 2-24, to protect the hose
from traffic weight, vibration and other effects which might cause damage. They can also be used in other places, such
as protecting the hose from rock, or from ballast and cinders under a railroad spur.
2-4.11
Flood Light Sets (6 Units)
NSN 6230-01-056-5238 GFE
a.
A flood light set is a wheel-mounted gasoline engine-driven generator with an integrally mounted telescoping
tower carrying three (3) high intensity lamps capable of lighting up to six acres. Essential information on the unit is as
follows:
Manufacturer: High Lite Corporation
Model HLT-3K-5K-MIL
Gasoline Engine Generator - 3KV, 12KV, 60 Hz
Fuel Capacity - 12.87 Gal.
3 Lamps - 1000 Watts ea. 3000 Watts total
100,000 Lumens ea. 300,000 Lumens total
2-24
|
