|
| |
TM 10-6630-247-138&P
2-7. ASSEMBLY AND PREPARATION FOR USE - cont.
d.
Setup Flash Point Tester. Refer to figure 2-7.
NOTE
Flash point tester refractory (heating element) is flush with top of heater
housing. If refractory is not flush, distillation unit heater and flash point
tester heater may have been switched.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Refer to loading plan (figure 2-6) and remove flash point tester components from
cabinet (1).
Close gas line needle valve (2).
Unfasten latch (3) and lower access panel (4).
If removed, close valve (5) by turning knob fully clockwise (to the right).
If removed, install valve (5) on propane cylinder (6).
Push one end of rubber tubing (7) onto cylinder valve (5). Push other end of tubing onto
gas line fitting (8) on flash point tester (9).
Loosen screw (10) and reposition cup holder (11) out away from dome (12). Retighten
screw.
Connect electrical cable (13) to power source.
Connect electrical cord (14) to electrical cable (13).
2 - 1 7
|
