| |
TM 10-6630-240-12&P
TM 01461B-12&P/1
b.
Remove the calibration pad (1) stored in kit. The pad is covered with a clear plastic shielding and has a coding
standard written on one side. Note the "Set" code in the center of the pad: this is the calibration setting you will use for
calibrating. The sample pad shown in Figure 2.18 has a calibration set code of 5.3 (2).
Figure 2-18
c.
Insert the Calibration Pad (1) in test area window (2) located on the bottom of the water detector (3): lift the
cover's curved metal tab (4) and place the pad (1) (text facing you) in the depressed circular area (5) or "window" located
in the center of the test area . Close the test area cover and stand the water detector upright. (figure 2-19)
Figure 2-19
2-14
|