|
|
TM 10-5430-239-12&P
0005 00
ASSEMBLY AND PREPARATION FOR USE
Installation Instructions
NOTE
If the tank is crated, perform removal from crate steps 1 through 9. If not, go to
skid placement steps.
Removal from the Crate
WARNING
Lifting or moving fuel tanks, berm liners or heavy equipment incorrectly
can cause serious injury. Do not lift or move more than 50 pounds (22.7 kg)
alone. Always get help from additional personnel or use proper lifting
equipment during lifting operations.
NOTE
Make sure the crated tank is in the proper position before beginning deployment.
It is very difficult to move the tank once it has been deployed.
1. Place the crate containing the tank in the middle of the prepared side. Place the end of the crate
marked "Consolidation Box" in the center of the deployment site. If the site has any slope, the length
of the crate must be parallel to the slope fall line.
2. Locate and remove lag bolts securing crate top to the sides. Lift crate top off and place outside of site
area.
3. Remove four filler/discharge hoses from inside crate and place outside of site area.
Typical Crate Setup
0005 00-3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |