|
| |
TM 10-5430-237-12&P
0018 00
0018 00-4
16. Once adhesive is tacky, bring ends of patch together (adhesive side out), and position center of
patch onto center of hole as shown.
17. Smooth down patch with edge of hand, one end at a time, so as to avoid any air bubbles.
18. Use a stitcher, or equivalent, to firmly roll down the entire patch, from center of patch out toward
edges to prevent formation of air bubbles.
19. If a second patch is being applied, proceed with step 20, below; otherwise proceed to step 22.
NOTE
Maximum shelf life of mixed adhesive is given in Table 2. If second patch is to
be applied, ensure that it is done within this time limit. Repair will not succeed
if mixed adhesive sits too long.
Table 2. Shelf Life of Mixed Adhesive
Temperature
41
F (5
C)
59
F (15
C)
77
F (25
C)
Use all material Within
25 minutes
20 minutes
10 minutes
20. Let first patch set for a few minutes (approximately 2 to 3).
21. Repeat steps 14 through 18, above, to apply second (outside) patch. Outside patch must be aligned
with inside patch (outline of inside patch will be visible).
22. Allow repair to set until cured before flexing fabric or putting tank back into service. Curing times are
given in Table 3.
|
