| |
TM 10-5430-237-12&P
0005 00
0005 00-13
8. If needed, clean the inside of the tank with a mild detergent and water solution and rinse thoroughly
with clean water.
9. Turn tank inside out and suspend (using inside handle) until thoroughly dry.
10. Shake out ground cloth to remove loose dirt and debris. If needed, spot clean ground cloth with a
mild detergent and water solution, and rinse with clean water. Allow ground cloth to dry thoroughly.
11. Take down the tank. Turn tank right side out so stencils are outside.
12. Quick connect the dust cap and dust plug to filler/discharge fittings and wrap fittings with cushioning
material.
Folding Models 91038, 90074 and 3-K-W-O-A/Z
CAUTION
Make sure the tank is completely dry before folding. Water will create mildew,
decreasing the life of the tank if it is not completely dry.
NOTE
Ensure fill/discharge fittings are positioned at the ends of the tank.
Throughout the folding process, be sure to brush off any stones, grass, or other
debris that may accumulate on the tank or the ground cloth.
Two personnel are required when folding and rolling up the tank and the ground
cloth to ensure that a tight bundle results.
1. Lay the tank out flat on the ground, with the tank collar up (1).
2. Grasp one side of the tank (2) (without a fill/discharge fitting), and fold inward toward the center (3).
3. Grasp the opposite side of the tank (3) and fold inward, over the first fold (4).
4. Fold any over-hang of the second fold back on top of itself (4).
5. Starting at one end of the tank (5), tightly roll up the tank (6).
6. Lay the cover out flat, float side up (7).
CAUTION
Do not walk on tank or cover, as damage may occur.
NOTE
If the fold lines have worn off, the length of the tank should run parallel to the ends of
the cover which have two handles each.
7. Lay the rolled up tank on the cover, with its length perpendicular to the two fold lines (7).
8. Fold one side of the cover, along the fold line, in over the tank (8).
|