|
| |
TM 10-5430-237-12&P
0005 00
0005 00-12
NOTE: Foot bellow, Models 91038 and
WT2008 not shown.
11. Keep the tank suspended until thoroughly dry.
12. Shake out ground cloth to remove loose dirt and debris. If needed, spot clean ground cloth with a
mild detergent (Item 4, WP 0030 00) and water solution, and rinse with clean water. Allow ground cloth to
dry thoroughly.
13. Take down the tank; position it with the handle-toggles (10) to the outside.
Draining and Drying (Models GTA-Z60TPW and 3-K-W-O-A/Z)
1. Drain all water from the tank.
2. Disconnect fill/discharge hose lines from ball valve assembly.
3. Disconnect ball valve assembly from tank fittings (6) and/or (7).
4. Clean the outside of the tank and cover (8) with a mild detergent and water solution and rinse
thoroughly with clean water.
5. Allow the exterior of the tank to dry thoroughly.
6. On Model GTA-Z60TPW, remove cover and unseal top opening on top of tank. On Model
3-K-W-O-A/Z, unzip top opening on tank.
CAUTION
Do not lift or move the inside lift handle if standing water is present. Do not
lift or move the tank by the inside lift handle if any standing water is
present in the bottom of the tank. Damage to the handle and/or tank fabric
may occur.
7. Using the inside lift handle (12), suspend the tank inside out. On Model 3-K-W-O-A/Z, there are two lift
handles (12).
NOTE: Model 90074 shown,
Other’s similar.
|
