|
| |
TM 10-5430-236-12&P
0020 00
0020 00-3/4 blank
3. Inspect compression plate (9) for cracks, corrosion and elongated bolt holes.
4. Inspect suction stub (14) for cracks, corrosion and bent support arms.
5. Inspect dust cap (7) for cracks or broken locking arms (20).
6. Inspect chain assembly (8) for damaged or broken connector and links.
REPAIR
Replace damaged components.
ASSEMBLY
1. Install new gasket (18) in dust cap (7).
2. Position new gasket (17) and flanged coupling half (3) on top of compression plate (9). Position
suction stub (14) with eight new packings with retainers (15) on bottom of compression plate (9).
Secure flanged coupling half (3) and gasket (17) to compression plate (9) with eight screws (16), new
lockwashers (13) and nuts (12).
3. Torque screws (16) to 96 in-lbs (10.84Nm). Refer to WP 0036 00 for torquing sequence.
4. Connect chain assembly (8) on dust cap (7) with key holder (19).
5. Install new gasket (18) in dust cap (7).
6. Lubricate new preformed packing (11) with silicone compound before assembly. Position preformed
packing (11) and compression plate (9) on compression fitting (10).
7. Position terminal end of chain assembly (8) on compression plate (9) and secure compression plate
(9) on compression fitting (10) with twenty screws (5) and flat washers (6).
8. Torque screws (5) to 120 in-lbs (13.56Nm). Refer to WP 0036 00 for torquing sequence.
9. Install two new gaskets (4) in filler elbow (2).
INSTALLATION
Open locking arms (1) on filler elbow (2). Push filler elbow (2) on flanged coupling half (3) and close
locking arms (1).
END OF WORK PACKAGE
|
