|
| |
TM 10-5430-236-12&P
0025 00
0025 00-1
UNIT MAINTENANCE
HOSE ASSEMBLY
REPAIR
INITIAL SETUP
Tools
General Mechanics Tool Kit
(Item 1, WP 0030 00)
Clamping Tool, Strap Band, Hose
(Item 4, WP 0030 00)
Equipment Condition
Hose assembly removed (WP 0008 00).
Drain valve removed (WP 0008 00).
Materials/Parts
Detergent, General Purpose
(Item 3, WP 0034 00)
Rag, Wiping
(Item 2, WP 0034 00)
Mandatory Replacement Parts
Determine materials required by hose size.
Hose Size
2-inch (5.08cm)
Gasket
(Item 2, WP 0037 00) (two required)
Seal
(Item 14, WP 0037 00) (four req’d)
Strapping Seal
(Item 12, WP 0037 00)
4-inch (10.16cm) Gasket
(Item 4, WP 0037 00) (two required)
Seal
(Item 15, WP 0037 00) (four req’d)
Strapping Seal
(Item 13, WP 0037 00)
6-inch (15.24cm) Gasket
(Item 9, WP 0037 00) (two required)
Seal
(Item 15, WP 0037 00) (four req’d)
Strapping Seal
(Item 13, WP 0037 00)
General Safety Instructions
WARNING
Do not smoke within 100 feet (30.5m) of tanks.
Fuel is toxic to skin, eyes, and respiratory tract.
NOTE
The following procedures apply to all hose assemblies used with the collapsible
fabric petroleum tanks.
DISASSEMBLY
1. Disconnect two key holders (1) from coupling half (2), chain (3), and dust plug (4).
2. Remove gasket (5) from coupling half (2). Discard gasket (5).
3. Cut two strappings (6) off hose (7). Remove coupling half (2). Discard strappings (6).
4. Disconnect two key holders (8) from coupling half (9), chain (10), and dust cap (11).
5. Remove gasket (12) from dust cap (11). Discard gasket (12).
6. Cut two strappings (13) off hose (7). Remove coupling half (9). Discard strappings (13).
REPAIR
Replace damaged components. Refer to WP 0035 00 for fabrication of chains.
|
