|
| |
TM 10-4930-248-13&P
5-3. CCR NOZZLE,
PISTON
MODEL,
ASSEMBLY
REPAIR
This task consists of:
a. Disassembly
b. Repair
c. Assembly
d. Testing
ENITIAL SET-UP:
Tools:
Materials/Parts
Required:
Tool Kit, General Mechanics (Item 1, Appendix B)
Rags (Item 2, Appendix F)
Body Wrench (Item 5, Appendix B)
Solvent (Item 1, Appendix F)
Piston Compression Tool (Item 7, Appendix B)
Bushing (Item 2, Appendix J)
Locking Lug Assembly Tool (Item 8, Appendix B)
Alcohol, Rubbing (Item 5, Appendix F)
Poppet Tool (Item 9, Appendix B)
Silicone Compound (Item 3, Appendix F)
Vise (with soft face jaws) (Item 4, Appendix B)
Sealing Compound (Item 4, Appendix F)
Piston (Item 9, Appendix J)
Sea], Sleeve (Item 4, Appendix J)
Seal, Wiper (Item 5, Appendix J)
Packing, Preformed (Item 6, Appendix J)
Seal, Teflon (Item 10, Appendix J)
Seal (Item 11, Appendix J)
Nut (Item 12, Appendix J)
Packing, Preformed (Item 14, Appendix J)
Ring, Backup (Item 13, Appendix J)
General Safety Requirements:
Equipment Condition:
WARNING
Nozzle removed from fuel system
•
Fuels are toxic and flammable. Do not get on
person or clothing. Do not use near open flame.
Area should be well ventilated. Do not smoke.
•
Using drycleaning
solvents incorrectly
can
cause injury or even death.
a.
Disassembly.
(1)
Remove dust cap and install piston compression
tool in coupling end of nozzle until it latches in place.
Do not remove piston compression
tool until directed to do so.
(2)
Push in latch actuator (1) and move handle (2) to OPEN position.
5-22
Change
1
|
