|
| |
TM 10-4930-245-13&P
CHAPTER 2
OPERATING INSTRUCTIONS
PARAGRAPH
TITLE
PAGE
Section I.
Description and Use of Operator's Controls and Indicators..........................
2-1
2.1.
Introduction .......................................................................................................
2-1
2-2.
Location and Use of Controls and Indicators ......................................................
2-2
Section H.
Preventive Maintenance Checks and Services (PMCS)..................................
2-3
2-3.
General .............................................................................................................
2-3
2-4.
PMCS Procedures .............................................................................................
2-3
2-5.
Cleaning Agents .................................................................................................
2-5
2-6.
Leakage Definitions for Operator PMCS ............................................................
2-5
2-7.
Explanation of Table Entries ..............................................................................
2-6
Section III. Operation Under Usual Conditions .................................................................
2-10
2-8.
Assembly and Preparation for Use......................................................................
2-10
2-9.
Operating Procedures ........................................................................................
2-10
2-10.
Decals and Instruction Plates..............................................................................
2-12
Section IV. Operation Under Unusual Conditions.............................................................
2-12
2-11.
Unusual Environmental/Weather ........................................................................
2-12
2-12.
Emergency Procedures .....................................................................................
2-13
2-13.
Nuclear, Biological, and Chemical (NBC) Decontamination Procedures..............
2-14
Section I.
DESCRIPTION AND USE OF OPERATOR'S CONTROLS AND INDICATORS
2-1.
INTRODUCTION.
This section describes the controls and indicators you, as the operator, will be using most often. The following
paragraphs will give you a brief description of each control and indicator.
2-1
|
