| |
TM 10-4930-240-13
4-42. STORAGE BOX ASSEMBLY REPAIR-cont.
c. Repair. Replace damaged or defective components.
d. Assembly. Refer to figure 4-29.
NOTE
Drill holes in panels by using angle brackets, channels, corner angles, skids, lift
handles, identification plates, latches, upper frame and lower frame as templates.
(1) Apply adhesive sealant on bottom panel (14) and install In lower frame (8), then secure with fifty four
rivets (12) and backup plates (13).
(2) Apply adhesive sealant on side panel (11) and install lower frame (8), then secure with sixteen rivets
(9) and backup plates 10. Repeat step for other end panel.
(3) Apply adhesive sealant on end panel (5) and install in lower frame (8), then secure with ten rivets (6)
and backup plates (7).
(4) Install corner angle (3) on panels (4 and 5) and secure with sixteen rivets (1) and backup plates (2).
Repeat step for remaining three corner angles.
Refer to figure 4-28.
(5) Install skid (17) on container (4) and secure with twenty rivets (15) and backup plates (16)-. Repeat
step for other skid.
(6) Install channel (14) on container (4) and secure with twelve rivets (12) and backup plates (13).
Repeat step for remaining three channels.
(7) Install bottom bracket (11) on container (4) and secure with two rivets (10). Repeat step for
remaining three angle brackets.
(8) Install top angle bracket (9) on container (4) and secure with two rivets (8). Repeat step for
remaining nine angle brackets.
(9) Install latch (7) on container (4) and secure with two rivets (5) and backup plates (6). Repeat step for
remaining three latches.
(10) Install lift handle (3) on container (4) and secure with ten rivets (1) and backup plates (2). Repeat
step for remaining three rings.
Refer to figure 4-27.
(11) Install ring (26) and clip (27) on container (10) with two screws (25), lockwasher (24) and nut (23).
Repeat step for remaining three rings.
(12) Install identification plate (22) on container (10) with four rivets (20) and backup plates (21).
4-82
|