|
| |
TM 10-4930-240-13
4-36. ELBOW ASSEMBLY REPAIR.
This task covers:
a.
Disassembly
b.
Cleaning
c.
Repair
d.
Assembly
INITIAL SETUP:
Tools:
Material/Parts:
General Mech Tool Kit (App B, Sect III, Item 1)
Cleaning Solvent
(Item 1, App E)
Equipment Condition:
Wiping Rag
(Item 2, App E)
Adapter assembly removed (para 4-13a)
Coupling Gasket
(Item 1, App J)
Coupling Gasket
(Item 4, App J)
NOTES
Ensure that all parts identified as mandatory replacement parts are discarded
and replaced with new components.
The following instructions are typical for all elbows supplied with the AFARE.
a. Disassembly. Refer to figure 4-24.
(1) Remove three spilt rings (1, 2, and 3) and chains (4 and 5).
(2) Remove dust cap (6) from male end of elbow (7).
(3) Remove gasket (8) from dust cap (6).
(4) Remove dust plug (9) from female end of elbow (7).
(5) Remove gasket (10) from female end of elbow (7).
b. Cleaning.
WARNING
Dry cleaning solvent, P-D-680, Type III, is potentially dangerous to personnel and
equipment. Eye and skin protection is required. Avoid repeated and prolonged
skin contact. Wash hands immediately after exposure. Do not use near open
flame or excessive heat. Use only in areas with good ventilation.
Using wiping rags and cleaning solvent, remove dirt and contaminants from all components.
c. Repair. Replace damaged or defective parts and all sealing components.
4-71
|
