|
| |
TM10-4930-239-12&P
Table 3-1. Operator Troubleshooting.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
PUMP ASSEMBLY WILL NOT START.
Step 1. Refer to operator sections of operator technical manual for p umping units and start pumps.
Step 2. Notify unit maintenance.
2.
PUMP ASSEMBLY STARTS BUT WILL NOT PUMP RATED CAPACITY.
Step 1. Inspect pump assembly for proper operation.
Refer to operator technical manual for pump assembly.
Step 2. Check that filter/separators are operating properly.
Refer to operator troubleshooting section of filter/separator operator technical manual.
Step 3. Check for proper combination of open and closed valves.
Refer to operating procedures in paragraph 2-8.
3.
PUMP ASSEMBLIES START, BUT FUEL CANNOT BE DISPENSED OR STORED.
Step 1. Pump assembly starts, but will not pump rated capacity.
Refer to malfunction 2.
Step 2. Fuel system valves are improperly set.
Refer to Operating Instructions in paragraph 2-8 to be sure that all FSSP valves have been
adjusted for the operation desired.
Step 3. Nozzle assembly is defective.
Replace nozzle assembly with a properly functioning nozzle assembly.
3-2
|
