|
| |
TM10-4930-239-12&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Section I. LUBRICATION
3-1. GENERAL. No lubrication is required for the FSSP itself, however, the pump units used with the FSSP do require
lubrication. Refer to the maintenance manual for the pump units for proper lubrication procedures.
Section II. OPERATOR TROUBLESHOOTING PROCEDURES
3-2. INTRODUCTION.
a. This section contains troubleshooting information for locating and correcting most of the operating troubles which
may develop in the FSSP. Each malfunction for an individual component, unit, or system is followed by a list of tests or
inspections which will help you to determine corrective actions to take. You should perform the tests/inspections and
corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed, or is not corrected by listed corrective actions, notify your supervisor.
c. Table 3-1 lists the common malfunctions which you may find during the operation or maintenance o f the FSSP or
its components. You should perform the tests/inspections and corrective actions in the order listed.
3-3. OPERATOR TROUBLESHOOTING PROCEDURES.
Refer to Table 3-1 for the operator troubleshooting procedures
authorized for the FSSP.
3-1
|
