|
| |
TM 10-4930-238-12&P
2-9. PREPARATION FOR MOVEMENT - Continued.
a. Teardown of Two-Point Refueling Operation - Continued.
(10) Pull ground rod (15) from the ground and stow with the filter/separator.
(11) Drain all fuel from filter/separator(16) and pumping assembly (17).
b. Teardown of Filling Operation. (Refer to Figure 2–9)
NOTE
Release camlock levers on individual components during preparation for move-
ment.
(1)
(2)
(3)
(4)
(5)
(6)
Remove ground cables (13 and 14) and stow on pumping assembly and filter/ separator.
Pull ground rod (12) from the ground and stow on filter separator frame.
Remove discharge hose (9) and elbow coupler valve (10) from drum (11) and drain fuel from
hose. Install dust caps and plugs. Stow discharge hose on frame and elbow coupler valve in
storage container.
Remove suction hose assemblies (7), (4), and (2) and drain fuel from hose assemblies. Remove
pressure control valve (7) and install dust caps.
Install dust caps on suction hose assemblies
and stow in container.
Remove adapter (1) and install dust caps. Stow adapter in container located on discharge hose
frame.
Drain fuel from pump assembly (3) and filter separator (5).
Figure 2–9. Piping Diagram for Filling Operation.
2-17
|
