|
| |
TM 10-4930-238-12&P
2-9. PREPARATION FOR MOVEMENT - Continued
a. Teardown of Two-Point Refueling Operation. (Refer to Figure 2-8).)
(1) Disconnect closed circuit nozzle ground cable (1) from helicopter.
(2) Disconnect ground cable (2) from ground rod. Pull ground rod (3) from the ground and stow
in suction hose assembly storage container.
Figure 2-8. FARE Schematic for Two-Point Refueling Operation.
NOTE
Place nozzle end of closed circuit nozzle in a suitable container and drain
fuel from system. Remove each hose assembly and individual fittings one
at a time. Drain fuel from each hose assembly and fittings into a suitable con-
tainer, before placing them into their storage containers.
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Remove closed circuit nozzles (4), install dust cap and stow in container located on dis-
charge hose assembly frame.
Remove discharge hose assemblies (5). Install dust cap and stow hose assembly on frame.
Remove wye fitting (6), install dust caps and dust plug. Stow wye fitting in container located
on discharge hose assembly frame.
Remove suction hose assemblies (7). Install dust caps and stow hose assemblies in the suc-
tion hose container.
Remove water detector adapter (8) and stow in container located on “y” discharge hose as-
sembly frame.
Remove elbow coupler valve (9), adapter (10), butterfly valve (11), and tee fitting (12). Install
dust caps and plugs. Stow all parts in container located on discharge hose container.
Disconnect ground cables (13 and 14) and stow with the pumping assembly and filter/sepa-
rator.
Change 1
2-15/(2-16 blank)
|
