|
| |
TM 10-4320-351-14
4.15.3 Repair Battery Cable. (Refer to figure 4-26.)
This task consists of:
a.
Removal
b.
Disassembly
c.
Assembly
d.
Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanics
Strap, Tiedown (Appendix F, Section II, Item 8)
(Appendix B, Section III, Item 1)
Packing (Appendix I, Item 75)
Washer, Lock (Appendix I, Item 78)
Washer, Lock (Appendix I, Item 79)
Equipment Condition:
Accessory module removed from system
(para. 2.9)
a.
Removal.
(1)
At the accessory module, open the center cover (1) and cable storage compartment cover (2).
(2)
Disconnect battery cable from battery.
(3)
Push battery cable through lower cut out into cable storage compartment and remove from accessory
module.
b.
Disassembly.
(1)
Remove tiedown straps and cable tags from battery cable.
(2)
At NATO connector (3), remove the six cross tip screws (4) and washers (5) that secure the cover (6) to the
connector.
(3)
Loosen the two jam nuts (7) completely.
(4)
Remove the two bolts (8) and lock washers (9) from the cable terminations. Remove the cables, jam nuts
(7), bushings (10) and packings (11) from the connector (3). Discard the lock washers (9) and packings
(11).
(5)
At the battery connector, remove two bolts (12) and flat washers (13) to separate connector (14).
(6)
Remove the two nuts (15) and lock washers (16) from the cable terminations. Remove the cables. Discard
the lock washers (16).
c.
Assembly.
(1)
At the battery connector (14), install two nuts (15) and lock washers (16) to secure the cable terminations to
the connector (14).
(2)
Install two bolts (12) and flat washers (13) to secure the connector (14) halves together.
4-48
|
