|
| |
TM 10-4320-351-14
c.
Install the two bolts (5) and washers (6) attaching gate (7). Feed fuel lines from injection pumps through lower
hole in gate (7).
d.
Position oil cooler (8) between crankcase and the fuel lines from injection pumps to the fuel injectors.
e.
Install socket head cap screw (9) and washer (10) attaching oil cooler to gate (7).
f.
Install two cross tip screws (11) attaching gate (12) and bracket (13) to cylinder head.
g.
Install union bolt (14), union (15), washer (16) and spacer (17) connecting the oil supply line at the oil cooler.
h.
Install union bolt (18), union (19), washer (20) and spacer (21) connecting the oil return line at the oil cooler.
i.
Install oil return line (22) to union (23) on crankcase.
j.
Install union bolt (24), washer (25), washer (26) and union (27) to connect oil supply line to crankcase.
k.
Install hand tight socket head cap screw (28) and washer (29) on back side of shroud (30).
l.
Install hand tight two cross tip screws (31) at top/intake side of shroud.
m.
Install hand tight socket head cap screws (32, 34 and 36) and washers (33, 35 and 37) attaching shroud.
n.
Tighten securely all shroud fasteners.
o.
Align oil cooler (8) and shroud (30). Install socket head cap screw (38), lock washer (39) and flat washer (40)
attaching shroud (30) to oil cooler (8).
p.
Install lifting eye (41), washer (42) and nut (43) on lifting eye studnut.
q.
On fuel feed line, assemble washers (44 and 45) as illustrated on union (46). Use bolt (47) to install assembly on
fuel pump.
r.
Use screw (49) , washer (50) and nut (51) to loosely install clamp (48) on gate (7).
s.
Fill engine with lubricating oil. Refer to table 4-1, item 1.
6-80
|
