|
| |
TM 10-4320-351-14
6.4.22 Install Valve Covers. (Refer to figure 6-46.)
This task consists of:
a. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
5 mm socket head wrench
Gasket (Appendix I, Item 23)
(Appendix B, Section III, Item 3)
3/8 in. drive ratchet wrench
(Appendix B, Section III, Item 3)
Equipment Condition:
Fuel injectors installed (para. 6.4.20)
a.
Position valve cover gasket (1) on cylinder head.
NOTE
Valve cover (2) with oil fill cap is positioned toward the PTO end of the engine.
b.
Position valve cover (2) on gasket (1) and cylinder head (3).
c.
If not adjusting fuel injection pump later, install and alternately tighten the socket head screws (4) attaching valve
covers (2) to cylinder head (3). If adjusting fuel injection pump 3, hand tighten only.
Figure 6-46. Valve Cover Installation
6-73
|
