| |
TM 10-4320-351-14
6.3.9 Remove Fuel Pump.
Refer to paragraph 4.14.2
6.3.10 Remove Fuel Injectors. (Refer to figure 6-9.)
This task applies to either fuel injector.
This task consists of:
a. Removal
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Combination Wrench, 10 mm
None
(Appendix B, Section III, Item 3)
Combination Wrench, 13 mm
(Appendix B, Section III, Item 3)
Combination Wrench, 17 mm
(Appendix B, Section III, Item 3)
General Safety Requirements:
Equipment Condition:
Cylinder casing removed (para. 6.3.2)
WARNING
Valve covers removed (para. 4.14.3)
Injector fuel feed lines removed (para. 6.3.8)
·
Fuels are toxic and flammable. Do not get on person
or clothing. Work in well ventilated area. Do not
smoke. Ensure equipment is well grounded.
NOTE
Copper washers under fuel injectors are used to adjust fuel injector protrusion into
combustion chamber of cylinder head. Record the number of washers removed, if
any, so that the same number of new washers will be installed upon reassembly.
a.
Remove brace nut (1), washer (2) and brace (3) from mounting stud (4).
b.
Raise fuel injector (5) for access and remove bolt (6), washer (7), union (8) and washer (9). Discard washers (7
and 9).
c.
Remove fuel injector (5) and washer(s) (10). Note number of washers (10) under fuel injector. Discard washers
(10).
6-17
|