|
| |
TM 10-4320-351-14
g.
Remove cover (18) and gasket (21). Discard gasket (21). Remove any gasket residue from the cover (18) and
crankcase.
h.
Remove two nuts (14) securing injection pump (2) to crankcase.
i.
Using needle nose pliers, remove three spring clips (22) from control rod (23), fuel injection pump and governor.
Raise fuel injection pumps enough to allow removal of control rod (23) from crankcase.
NOTE
Refer to figure 6-8. Before removal, mark each fuel injection pump to ensure that
the pump will be reinstalled in the same location. Record and retain the number of
gaskets, if any, that were between the injection pump and the crankcase. The
same number of gaskets must be used upon reassembly.
Refer to figure 6-8.
j.
Remove injection pump (1) and gasket(s) (2) from crankcase.
k.
Remove expansion plug (3) and tappet (4) from crankcase.
Figure 6-8. Injection Pump Removal
6-16
|
