|
| |
TM 10-4320-351-14
6.3.2 Remove Engine Shroud, Cylinder Casing and Gates. (Refer to figure 6-3.)
This task consists of:
a. Removal
INITIAL SET-UP:
Tools:
General Safety Requirements:
Combination Wrench, 6 mm
(Appendix B, Section III, Item 3)
Fuels are toxic and flammable. Do not get on
Key, Socket Head Screw, 5 mm
person or clothing. Work in well ventilated area.
(Appendix B, Section III, Item 3)
Do not smoke. Ensure equipment is well grounded.
Combination Wrench, 19 mm
(Appendix B, Section III, Item 3)
Combination Wrench, 13 mm
(Appendix B, Section III, Item 3)
Materials/Parts Required:
Handle, Socket Wrench, Ratchet, 1/4" Drive
None
(Appendix B, Section III, Item 3)
Socket, Deep Well, 7 mm, 1/4" Drive
(Appendix B, Section III, Item 3)
Extension, Socket, 3 in.,1/4" Drive
(Appendix B, Section III, Item 3)
Equipment Condition:
Handle, Socket Wrench, Ratchet, 1/2" Drive
Engine removed from engine module
(Appendix B, Section III, Item 3)
(para. 6.2)
Socket, Deep Well, 13 mm, 1/2" Drive
Engine oil drained
(Appendix B, Section III, Item 3)
(Table 4-1)
Extension, Socket, 3 in., 1/2" Drive
(Appendix B, Section III, Item 3)
Screwdriver, Cross Tip, #2
(Appendix B, Section III, Item 3)
Combination Wrench, 1/4 in.
(Appendix B, Section III, Item 3)
a.
Remove cable clamp (1) from fuel flow solenoid cable at black start control knob (2).
b.
Remove two socket head cap screws (3) and washers (4). Remove cylinder casing (5).
c.
Remove the socket head cap screw (6), lock washer (7) and flat washer (8) attaching oil cooler (9) to shroud (10).
Discard lock washer (7).
d.
Remove the two cross tip screws (11) at top/intake side of shroud (10).
e.
Remove four socket head cap screws (12) and washers (13) attaching shroud (10). Remove shroud (10).
f.
Remove two cross tip screws (14) attaching gate (15) and bracket (16).
6-7
|
