Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: REMOVE ENGINE FROM ENGINE MODULE.
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 10-4320-351-14 e. Remove  two  socket  head  cap  screws  (8)  and  washers  (9)  securing  cylinder  casing  (10)  to  cylinder   heads. Remove casing (10). f. Place drain pan under fuel pump (11). g. Remove fuel supply line (12) from fuel pump (11). h. Remove fuel return line from fuel fitting (13) on #2 fuel injection pump. i. Cut and remove tiedown straps from electrical wiring harness. j. Tag and disconnect fuel shutoff solenoid electrical wires (14) at in-line connectors in wiring harness. k. Tag and disconnect engine temperature sensor electrical wire (15) at in-line connector in wiring harness. I. At intake manifold, lift boots (16) from air intake heaters. m.    Tag and remove electrical wires (17) from air intake heaters. n. Tag and remove electrical wire (18) from oil pressure switch. o. Tag and disconnect alternator wires (19) at in-line connector in wiring harness. p. Tag and remove small electrical wire (20) from starter solenoid. q. Tag and remove cables and wires (21) from starter solenoid. r. At lower starter mounting bolt (22), tag and remove all electrical wires. s. Unlatch and lower pulley guard (23). WARNING Serious  injury  could  occur  if  heavy  equipment  is  moved/lifted  without  sufficient personnel to do the job.  Always use four personnel to move or relocate the engine module.  Use proper physical lifting procedures or use a suitable lifting device or dolly.  Wear safety shoes, gloves and other suitable protective clothing. NOTE The engine is secured to the module frame by ten hex head bolts, five on each side of the engine.  Before removing these bolts, the engine must be supported to take the weight off the mounting bolts.  A hoist may be attached to the engine lifting eye or the engine may be blocked from underneath if a hoist is not available. t. Attach hoist to engine lifting eye (24) and take all slack out of hoist cable/chain, or block engine from underneath to take engine weight off mounting bolts. u. Remove  the  ten  mounting  bolts  (25),  lock  washers  and  flat  washers  and  hoist  the  engine  from  the  module. Discard the lock washers. 6-3

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business