|
| |
TM 10-4320-351-14
(2)
Remove rotary vane pump housing. Refer to paragraph 5.4.3.
(3)
Remove rotary vane pump components. Refer to paragraph 5.4.4.
(4)
Remove inlet. Refer to paragraph 5.4.1.
(5)
Slide impeller-shaft assembly out of housing.
NOTE
Do not attempt to remove carbon bearing in impeller housing. This bearing can
only be installed at the depot.
b.
Installation.
(1)
Slide replacement impeller-shaft assembly into housing.
(2)
Install inlet. Refer to paragraph 5.4.1.
(3)
Install rotary vane pump components. Refer to paragraph 5.4.4.
(4)
Install rotary vane pump housing. Refer to paragraph 5.4.3.
(5)
Install rotary shaft seal housing and components. Refer to paragraph 5.4.2.
5-18
|
