|
| |
TM 10-4320-351-14
(9)
Place the outer side plate (6) over the rotor (8) so that mounting holes are aligned, and the fuel inlet/outlet
ports are aligned with sixteen flow holes in the cam ring (14). (The inside face has grooves connecting the
inlet/outlet ports.)
(10)
the clamp plate (5) over the outer side plate (6) so that mounting holes are aligned. Apply anti-seize
compound to and install the four socket head screws (1), lock washers (2) and flat washers (3). Tighten the
screws finger tight, then tighten in a crossing pattern.
(11)
rotary vane pump housing. Refer to paragraph 5.4.3.
(12)
Install rotary shaft seal housing and components. Refer to paragraph 5.4.2.
5.4.5 Replace Fuel Transfer Pump Impeller-Shaft Assembly.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools:
Material/Part Required:
Key, Socket Head Screw, 9/64 in.
(Appendix B, Section III, Item 3)
WARNING
Key, Socket Head Screw, 3/16 in.
Fuels are toxic and flammable. Do not get on
(Appendix B, Section III, Item 3)
person or clothing. Work in well ventilated area.
Key, Socket Head Screw, 5/16 in.
Do not smoke. Ensure equipment is well
grounded.
(Appendix B, Section III, Item 3)
Wrench, Combination, 7/16 in.
Materials/Parts Required:
(Appendix B, Section III, Item 3)
Petrolatum (Appendix F, Section II, Item 10)
Wrench, Combination, 1-1/16 in.
Anti-Seize Compound, Molybdenum Disulfide
(Appendix B, Section III, Item 3)
(Appendix F, Section II, Item 3)
Wrench, Strap
Safety Wire, MS20995C20
(Appendix B, Section III, Item 3)
(Appendix F, Section II, Item 5)
Adapter Crow Foot
(Appendix B, Section III, Item 3)
Equipment Condition:
Screwdriver, Flat Blade, 1/4 in. x 4 in.
Fuel transfer pump removed from pump-engine
(Appendix B, Section III, Item 3)
module. (para. 4.12.1)
Wire Twister, Plier
(Appendix B, Section III, Item 3)
Personnel Required:
Plier, Diagonal Cutting
Two, any MOS
(Appendix B, Section III, Item 3)
Wrench, Torque, 0-150 ft lb
(Appendix B, Section III, Item 3)
a.
Removal.
(1)
Remove rotary shaft seal housing and components. Refer to paragraph 5.4.2.
5-17
|
