|
| |
TM 10-4320-348-14
SECTION VII. PREPARATION FOR MOVEMENT, STORAGE OR SHIPMENT
4.37 PREPARATION FOR MOVEMENT. (Refer to Figure 4-31)
a.
Remove ground rod (1) from earth and remove one end of grounding cable (2) from pump ground connection (3).
b.
If an auxiliary fuel tank is used as a fuel supply source, disconnect the supply hose from AUX FUEL fitting and the
auxiliary fuel tank.
Figure 4-31. Ground Rod and Auxiliary Fuel Line Removal
4.38 PREPARATION FOR STORAGE OR SHIPMENT.
a.
Intermediate Storage (46 to 180 days).
(1)
Operate engine for about 3 minutes and then stop.
(2)
Remove lube oil drain plug and allow the engine lube oil to drain into a suitable container while the engine is
still warm.
(3)
Open pump fluid drain cock and allow pump to drain into a suitable container.
(4)
Remove drain plug on fuel tank and allow tank to drain into a suitable container.
(5)
Replace fuel tank drain plug and lube oil drain plug. Close pump fluid drain cock.
(6)
Remove oil dipstick and fill engine with new lube oil. Replace dipstick. Refer to Appendix F for lubrication
instructions.
(7)
Remove rubber plug on cylinder head and add about 5 drops of lube oil. Replace rubber plug.
(8)
Hold decompression lever down and slowly pull recoil starter rope 2 or 3 times (do not start engine).
4-65
|
