|
| |
TM 10-4320-347-13&P
4.8. FRAME ASSEMBLY REPLACEMENT.
This task covers:
a.
Removal
b.
Replacement
INITIAL SETUP:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Materials Required
Lock Nuts (Appendix H, Item 2)
Lock Washers (Appendix H, Item 1)
Equipment Condition
Pump assembly shut down and cool.
WARNING
Death or serious injury could occur if fuel is not handled carefully. Use in a well-
ventilated area away from open flame, arcing equipment, ignition sources, heaters,
or excessive heat. Use proper marked containers. DO NOT SMOKE.
Fuel drained from system (see para. 2.12.).
Slave cable disconnected from 24 volt power source.
All hose assemblies disconnected from pump (see para. 2.12.).
a.
Removal (Refer to Figure 4-6).
(1) Remove two bolts (1) and two lock washers (2) from frame (3). Discard lock washers.
(2) Remove four bolts (4), eight flat washers (5), and four lock nuts (6). Discard lock nuts.
(3) Remove pump and motor assembly (7).
b.
Replacement.
(1) Install pump and motor assembly (7) into frame (3).
(2) Install four bolts (4), eight flat washers (5), and four lock nuts (6) through frame (3). Do not
tighten hardware.
(3) Install two lock washers (2) and two bolts (1).
(4) Tighten all mounting hardware. Refer to Appendix G for torque values.,
4-11
|
