|
| |
TM 10-4320-347-13&P
NOTE
Only use those authorized cleaning solvents or agents listed in Appendix F.
CAUTION
Keep cleaning solvents, gasoline, and lubricants away from
rubber or soft plastic parts. They will deteriorate material.
Cleaning Rust or Grease. When cleaning grease buildup or
rusty places, use cleaning solvent (P-D-680). Then apply a thin
coat of light oil to affected area.
2.5. LEAKAGE DEFINITIONS FOR OPERATOR PMCS . Because the pump assembly is designed to
be used in the pumping of extremely flammable liquid fuels, NO LEAKS ARE PERMITTED. If any
component of the pumping assembly exhibits any type of leak (including even simple seepage of fluid as
indicated by wetness or discolorization), stop the pumping unit immediately and notify your supervisor.
2.6. SPECIAL INSTRUCTIONS . If the equipment must be kept in continuous operation, check and
service only those items that can be checked and serviced without disturbing operation. Make the
complete checks and services when the equipment can be shut down.
Perform weekly as well as before operation PMCS if:
(1) You are the assigned operator and have not operated the item since the last weekly.
(2) You are operating the item for the first time.
Within designated interval, these checks are to be performed in the order listed.
2.7. OPERATOR'S PMCS TABLE.
TABLE 2-1. Operator Preventive Maintenance Checks and Services for Model FB4320-35.
CAUTION
During PMCS it may be necessary to run the pumping
assembly. Since the pump is directly coupled to the motor, the
pump will run when the motor runs. Running the pumping
assembly for longer than a few seconds without liquid in the
pump side will damage the pump. When necessary to run the
pump for longer than a few seconds, make sure that suction and
discharge hoses are installed and a source of fuel is available.
Start pumping assembly, prime and operate pump to duplicate
normal operation and prevent pump from overheating.
2-5
|
