Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: Startup for Regulated Models.
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 10-4320-343-14 h. i . j . k. 1. m. n. o . Do  not  operate  350  GPM  Pumping  Assembly  without  grounding. Do   not   operate   equipment   in   enclosed   area   unless   exhaust   gases   are piped   to   outside   and   adequate   ventilation   is   provided. Avoid inhalation   of   exhaust   fumes. Do   not   stand   within   50   feet   of   operating   equipment   without ear   protection. Failure  to  obey  these  warnings  may  result  in  hearing  lose. Do   not   operate   starter   motor   for   more   than   10   seconds,   damage   to starter   can   result. Push   in   start   switch   (8)   and   oil   pressure   bypass   switch   (9)   simultaneously. After   10   seconds,    release   start   switch. (1)   If   engine   does   not   start,    release   oil   pressure   bypass minutes   and   repeat   steps   h   and   i. If   engine   does   not repeated    attempts,    refer   to   operator   troubleshooting. (2)   When   engine   starts,    release   start   switch   (8)   . switch,   wait s t a r t    a f t er two The   engine   will   shutdown   when   oil   pressure   bypass   switch is   released   if   oil   pressure   is   not   4   psi   or   above. Release   oil   pressure   bypass   switch   (9)   when   oil   pressure   is   indicated   on gauge   (10). Allow   engine   to   warm-up   at   idle   RPM   for   two   minutes. Open   suction   valve   (2)   that   is   connected   to   suction   line. Observe   the   end   of   vent   line   (12)   for   liquid   flowing   from   it. Once   liquid begins   to   flow   from   line,   close   vent   valve   (1)  . Ensure  discharge  valve  is  open. Pump   can   overheat   if   discharge valve   is   closed   for   long   periods   of   time. A   vapor-locked condition   may   result. If   this   occurs,    shutdown   engine   and   allow pump   to   cool   before   filling   housing   with   liquid. Slowly   open   discharge   valve   (3)   that   is   connected   to   discharge   line. place  mode  selector  (6)  to  MANUAL  position  and  rotate  the  manual  speed control   (5)   clockwise   until   gauge   (11)   indicates   approximately   2400   RPM. 2-23 NOTE

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business