| |
TM 10-4320-343-14
4.10.20 Oil Line Maintenance.
This task covers:
4.10.20.1 Removal
4.10.20.2 Installation
INITIAL SETUP
Tools
Equipment Conditions (continued)
General Mechanics Tool Kit (appendix B,
Fuel feed pump removed
Section III, Item 1)
(paragraph 4.10.10.17).
Low oil pressure switch and sending
unit removed (paragraph 4.10.19).
General Safety Instructions
Equipment Conditions
Equipment shut down, refer to
paragraph 2.5.1.2 or 2.5.2.2.
To prevent rolling or sliding, do not
work on equipment that is not securely
stabilized.
Do not work on equipment without
following standard shop safety
precautions.
Figure 4-30.
Oil Line Maintenance.
4.10.20.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personal injury.
a.
Remove banjo bolt (1) and washers (2) .
b.
Remove oil line (3).
4.10.20.2 Installation.
a.
Position oil line (3) between oil and fuel filter housing and injection pump.
b.
Install washers (2) and banjo bolt (1).
4-58
|